10A 12V | 24V EPHC10-ST PWM Solar Charge Controller
Solar regulator EPHC10-ST for solar home systems.
This is 10 Amps 12/24V auto switch solar charge controller,it can work for your 240W solar panel.
The EPHC10-ST Solar Charge Controller is ideal for rural electrification systems. It provides many features and benefits.
Features:
1.Use MCU and professional software as the control center to fulfill intelligent system control.
2.The accurate control point depends on the battery discharge rate, final discharging voltage is the control point of corrected discharging curve. eliminate the discrepancy by the single voltage control, meet the battery characteristics, which is different charge rate has different final voltage.
3.With intelligent protection against over charging, over discharging, electronic short-circuit, over load, polarity reverse and etc. no damage for any components, and no burning for the fuse.
4.With series PWM charging circuit, the voltage loss of charging loop is only half of the LED charging circuit, the charging efficiency is higher 3%-6% than the ON/OFF one, and saved the energy. The boost, direct, and float charging enhanced the lifetime of the system. Also it has specific temperature compensation.
5.Direct LED indicator for the statues of the system.
6.With Flash memory saving the control point, make the setting digital, eliminate the discrepancy
7.One key setting, easy and convenient.
EPHC10-ST Solar Charge Controller Data Sheet
Type
EPHC10-ST 10A
Rated charge current
10A
Rated load current
10A
Work voltage
12V/24V
Equalization voltage Boost
voltage Float voltage
14.8 V 14.4V 13.6V
Low voltage Disconnect
11.1V
Low voltage Reconnect
13.1 V
Type of Charging
Series PWM & SOC 4 Stages: equalization, PWM, Boost and
Float, temperature compensated charging
Electronic protections
Short circuit and over current-solar and load Reverse polarity
solar, load, battery Reverse current at night Limits high voltage to
protect loads Lighting protection
10A 12V | 24V EPHC10-ST PWM Solar Charge Controller
Posted by admin in News
10A 12V | 24V EPHC10-ST PWM Solar Charge Controller
Solar regulator EPHC10-ST for solar home systems.
This is 10 Amps 12/24V auto switch solar charge controller,it can work for your 240W solar panel.
The EPHC10-ST Solar Charge Controller is ideal for rural electrification systems. It provides many features and benefits.
Features:
1.Use MCU and professional software as the control center to fulfill intelligent system control.
2.The accurate control point depends on the battery discharge rate, final discharging voltage is the control point of corrected discharging curve. eliminate the discrepancy by the single voltage control, meet the battery characteristics, which is different charge rate has different final voltage.
3.With intelligent protection against over charging, over discharging, electronic short-circuit, over load, polarity reverse and etc. no damage for any components, and no burning for the fuse.
4.With series PWM charging circuit, the voltage loss of charging loop is only half of the LED charging circuit, the charging efficiency is higher 3%-6% than the ON/OFF one, and saved the energy. The boost, direct, and float charging enhanced the lifetime of the system. Also it has specific temperature compensation.
5.Direct LED indicator for the statues of the system.
6.With Flash memory saving the control point, make the setting digital, eliminate the discrepancy
7.One key setting, easy and convenient.
EPHC10-ST Solar Charge Controller Data Sheet
voltage Float voltage
Float, temperature compensated charging
solar, load, battery Reverse current at night Limits high voltage to
protect loads Lighting protection